Nice dream, sounds like you have a good chance of success.Xylog wrote: ↑Thu Jul 30, 2020 6:42 pm I Figure if I cut the hole just slightly bigger than the magnet & raise the magnet up to cover the thickness of the protector I shouldn't have hanging issues.
That's the dream
Also, for your issue - I think I read on the HardTops thread that you should pop the rollover insert & re-seat it slightly higher to prevent hang. Too much work IMHO.
I definitely won't be popping out the rollover insert! It might help but only if the hole was a very close fit, at least near the bottom edge. If there is a gap then this happens. Target height is correct, but the space between target and edge of protector leaves a hollow.